Sulky Filmoplast selbstklebendes Ausreißvlies 50 cm × 25 m in Weiß
  • Sulky Filmoplast 50 cm × 25 m in White
  • Sulky Filmoplast selbstklebendes Ausreißvlies 50 cm × 25 m in Weiß
  • Sulky Filmoplast selbstklebendes Ausreißvlies 50 cm × 25 m in Weiß
  • Sulky Filmoplast selbstklebendes Ausreißvlies 50 cm × 25 m in Weiß

Sulky Filmoplast – for everything that cannot be hooped

Filmoplast is hooped on its own. You then score the backing paper, peel it off and press the fabric onto the exposed surface. That way you can stitch pieces which fit into no hoop at all.

  • Self-adhesive
  • Tear away
  • No hooping
Size: 50 cm × 25 m 3 zur Auswahl
Colour: White 2 zur Auswahl
110,00 EUR 8,80 EUR per m²
incl. 19% tax excl. Shipping costs
Pcs.:
ca. 3-5 days ca. 3-5 days Stock: 10 Pcs.

Zur Einzelseite dieser Variante

Daten zum Artikel

Width
50 cm
Colour
Weiß
Length (m)
25 m
Material
75 % Cellulose, 25 % Polyester

Alle 2 Varianten in 50 cm × 25 m

Alle 6 Kombinationen

Some places simply cannot be hooped: a collar, a cuff, the front of a cap, a patch pocket already sewn on. Forcing it distorts the finished piece, or the hoop will not close at all. A self-adhesive stabiliser solves this, because only the stabiliser itself gets hooped.

The routine never changes: hoop the stabiliser paper side up, score the paper with a needle point and peel it away across the middle. The adhesive layer lies underneath. Lay the fabric on, smooth it down — and only then start the machine.

After stitching you lift the fabric off and tear the remaining stabiliser away around the design. For firm or very stretchy fabrics the same idea comes one step heavier: Filmoplast Strong at 95 g/m².

Good to know

How do I score the backing paper properly?

With a needle point or a seam ripper, held flat and cutting through the paper only. Score a rectangle slightly smaller than the hoop, so enough paper remains around the edge to keep the hoop clean.

Does the adhesive hold on smooth fabrics?

On most, yes. With very smooth or coated surfaces, test on an offcut: if the fabric lifts while stitching, pin the edges outside the design area for extra security.

When should I use Filmoplast Strong?

When the fabric is firm, stretches a lot, or the design sets many stitches. The heavy version then pushes back better; for shirting, caps and light goods the standard Filmoplast is enough.