Two-Way Open End Zip 80 cm Denim Blue
Item no. 29023
€6.90per piece
Unit price €8.63 / m · incl. VAT, plus shipping
Moulded open end zip in denim blue with two sliders and a length of 80 cm. It opens from the top and from the bottom, separates fully at the box and is made for long jackets, parkas and coats.
Colour: Denim Blue (220)
only a few left
Delivery time approx. 3–5 working days
Free shipping within Germany from €50
- Material
- 100 % Polyester
- Colour
- Jeansblau
- Care
Wash at 40°C
Iron at medium temperature
Wash without fabric softener or bleach- dry
- Breite des RV
- 3,2 cm
- Verschlussart
- teilbar
- Schieber
- 2-Wege
- Ausführung
- Krampe
- Breite
- 5 mm
- Länge (cm)
- 80 cm
- Farbcode
- 220
Description
<p>Denim blue is made for denim, chambray and long jean jackets. It also looks fresh on beige and white without shouting. At 80 cm the zip reaches from hem to collar on many short coats and hip-length parkas.</p><p>Two sliders run on the same row of teeth. The upper one closes as usual, the lower one opens the jacket from below so it does not pull when you sit. At the box both halves separate completely. The 5 mm moulded plastic teeth are tough, run firmly and are easy to handle even with gloves.</p><p>Length is measured as tooth length from stopper to stopper, without the tape. Colour code 220.</p>
What Two-Way Open End Zip 80 cm Denim Blue is suitable for
- Long coats, because the lower slider gives room when walking and sitting.
- Parkas, because the front stays closed at the top while the hem is open.
- Children's snowsuits, because dressing from below gets easier.
Sewing tips
- Länge am fertigen Schnittteil messen, nicht am Schnittmuster – Nahtzugaben und Saum verändern die gebrauchte Länge.
- Vor dem Einnähen beide Schieber zusammen nach oben ziehen und den Verschluss schließen, dann liegen die Hälften gleich hoch.
- Reißverschlussfuß verwenden; an den Schiebern die Nadel unten lassen, Fuß anheben und die Schieber vorbeischieben.
- Beide Seiten auf gleicher Höhe heften. Verschiebt sich eine Hälfte, steht die Jacke am Saum auseinander.
- Bei dehnbaren Stoffen den Beleg mit Vlieseline verstärken, sonst wellt sich die Kante entlang des Bandes.
- Krampenverschlüsse nicht direkt bügeln, die Kunststoffzähne vertragen keine Hitze.
- Beim Waschen den Verschluss schließen, dann verzieht sich das Band nicht.
Available in more colours in the 2-Wege-Reißverschlüsse series.
Care instructions:
Frequently asked questions
How do I position the sliders when sewing in?
Close the zip and pull both sliders up together. Then the halves sit level. When sewing past the sliders, leave the needle down, lift the foot and slide them past it.
Can I shorten the zip?
Yes, but only from the top, because the box and pin sit at the bottom. Remove a few teeth at the top, set a new stop with hand stitches and make sure the upper slider cannot slip off.
How do I separate the two halves?
Push both sliders all the way down until they rest against the box. Only then does the pin slide out. If the lower slider sits too high, it holds the halves together.
How do I measure the right length?
Measure the front edge on the finished pattern piece from hem to neckline and deduct the seam allowances. If the measurement falls between two lengths, take the longer one and shorten it at the top.