Separating Zip 75 cm Grey Green
€3.10per piece
Unit price €4.13 / m
Free shipping within Germany from €50 · Pay securely with PayPal and Klarna

Item no. 29047
€7.10per piece
Unit price €7.89 / m · incl. VAT, plus shipping
Moulded open end zip in grey green with two sliders and a length of 90 cm. It opens from the top and from the bottom, separates fully at the box and is made for long jackets, parkas and coats.
currently out of stock — back soon
Free shipping within Germany from €50
<p>Grey green is a quiet grey with a hint of green for outdoor jackets, parkas and loden coats. It pairs with olive, taupe and stone grey and never pushes to the front. At 90 cm the zip is long enough for coats that reach mid-thigh.</p><p>Two sliders run on the same row of teeth. The upper one closes as usual, the lower one opens the jacket from below so it does not pull when you sit. At the box both halves separate completely. The 5 mm moulded plastic teeth are tough, run firmly and are easy to handle even with gloves.</p><p>Length is measured as tooth length from stopper to stopper, without the tape. Colour code 326.</p>
Available in more colours in the 2-Wege-Reißverschlüsse series.
Close the zip and pull both sliders up together. Then the halves sit level. When sewing past the sliders, leave the needle down, lift the foot and slide them past it.
Yes, but only from the top, because the box and pin sit at the bottom. Remove a few teeth at the top, set a new stop with hand stitches and make sure the upper slider cannot slip off.
Push both sliders all the way down until they rest against the box. Only then does the pin slide out. If the lower slider sits too high, it holds the halves together.
Measure the front edge on the finished pattern piece from hem to neckline and deduct the seam allowances. If the measurement falls between two lengths, take the longer one and shorten it at the top.

€3.10per piece
Unit price €4.13 / m

€3.20per piece
Unit price €4.00 / m

€3.30per piece
Unit price €3.88 / m