Steel grey is a mid grey with a slight blue cast. It reads cooler and more technical than a neutral grey. 65 cm — that length is measured without the tape running into the seam above and below.
A 5 mm plastic coil — the version fitted to most jackets. Insert it with a zip foot so your seam runs close beside the teeth. Three to five millimetres is right: closer and the slider brushes it, further and the fabric throws a ripple.
What Teilbare Reißverschlüsse Stahlgrau is suitable for
- Zipped hoodies, because the fastener can run up into the hood.
- Children's jackets, because the piece goes on and off easily.
- Between-season jackets, because they open quickly.
Sewing tips
- Länge am fertigen Schnittteil messen, nicht am Schnittmuster — Nahtzugaben und Saum verändern die gebrauchte Länge.
- Reißverschlussfuß verwenden. Mit ihm kommt die Naht dicht an die Zähne, ohne dass der Fuß aufläuft.
- Vor dem Annähen beide Seiten gleich hoch ausrichten und heften. Verschiebt sich eine Hälfte, steht die Jacke am Saum auseinander.
- Bei dehnbaren Stoffen den Beleg mit Vlieseline verstärken, sonst wellt sich die Kante entlang des Bandes.
- Den Schieber vor der Quernaht öffnen und beiseiteschieben, damit die Nadel nicht auf Metall trifft.
- Metall- und Krampenverschlüsse nicht bügeln. Bei Spiralverschlüssen nur mit Tuch und niedriger Stufe.
- Beim Waschen den Verschluss schließen, dann verzieht sich das Band nicht und die Zähne haken sich nicht in anderer Wäsche fest.
Available in more colours in the Teilbare Reißverschlüsse series.
Frequently asked questions
Which presser foot should I use?
A zip foot. It runs beside the teeth rather than over them, so your seam comes close enough and keeps an even distance.
Metal or plastic — which is better?
Plastic is lighter, more flexible and quieter; metal reads stronger and takes more strain. Sweat jackets do fine with plastic; for coats and workwear, metal serves better.
How exactly must the colour match?
On a jacket the fastener lies open, so close inspection pays off here. If unsure, take the next darker shade — or go for deliberate contrast.
How far should the topstitching sit?
About three to five millimetres beside the teeth. Too close and the slider brushes your seam; too far and the fabric throws a ripple over the tape.
Care instructions:


