Dark grey is the restrained alternative to black. On mid-tone fabrics it draws a line without reading as hard. 22 cm suffices for a short back opening on a blouse, or for a zipped compartment in a bag. That opening stays discreet.
A fine coil, 3 mm wide, on a polyester tape. On stretch fabrics a narrow stay tape in the seam allowance pays off, so your edge will not stretch as you sew or ripple later. Measure the length on your finished pattern piece, not on paper: the stated length is tooth length, and the tape above it disappears into your seam allowance.
What Nahtverdeckte Reißverschlüsse Dunkelgrau is suitable for
- Skirts with a short opening, because that seam reads closed.
- Blouses fastening at the back, because nothing adds bulk.
- Decorative cushions, because this fastener never catches an eye.
Sewing tips
- Ein spezieller Nähfuß für nahtverdeckte Reißverschlüsse ist praktisch Pflicht — er rollt die Spirale auf und führt die Naht direkt darunter.
- Der Verschluss wird eingenäht, BEVOR die Naht darunter geschlossen wird. Das ist umgekehrt zum normalen Reißverschluss.
- Vor dem Nähen die Spirale mit dem Bügeleisen auf niedriger Stufe flach ausrollen, dann kommt die Naht nah genug an die Zähne.
- Beide Seiten von oben nach unten nähen, nicht gegenläufig — sonst verzieht sich die eine Seite gegen die andere.
- Am unteren Ende so weit nähen, wie der Fuß kommt, dann den Rest der Naht mit normalem Fuß schließen und die letzten Zentimeter von Hand verriegeln.
- Bei dehnbaren Stoffen ein schmales Formband oder Vlieseline in die Nahtzugabe legen, damit die Kante gerade bleibt.
- Zum Waschen schließen und nicht direkt über den Schieber bügeln.
Matching colour code 312
Available in more colours in the Nahtverdeckte Reißverschlüsse series.
Frequently asked questions
In what order do I sew?
The opposite way round from an ordinary zip: first sew the fastener into the open edges, then close the seam below it. Sew first and insert after, and you will never get it neatly under.
Should I press the coil first?
It helps a great deal. Roll the coil flat with an iron on a low setting, then your seam comes close enough to the teeth and the fastener disappears fully into the seam.
Can I shorten it?
From the top yes: cut it off, fold the tape into your seam allowance and set a new stop with a few hand stitches. From the bottom you cannot, that is where the fixed stop sits.
Does it work on jersey?
Yes, if you stabilise the edge. A narrow stay tape or a strip of interfacing in your seam allowance stops that edge stretching as you sew and rippling afterwards.