Ice blue is a very pale, cool blue with a grey cast. It reads fresh without being as childish as baby blue. At 80 cm of tooth length it fits wherever you need exactly that opening — measured on your finished pattern piece, not on paper.
This version carries 5 mm metal teeth. They take more strain than plastic but need more clearance from your needle while sewing. Close the fastener before every wash. The tape then will not distort and the teeth cannot catch in other laundry. Never press directly over the slider.
What Teilbare Reißverschlüsse Eisblau is suitable for
- Coats, because this length reaches the hem.
- Covers meant to come off entirely, because both halves separate.
- Between-season jackets, because they open quickly.
Sewing tips
- Länge am fertigen Schnittteil messen, nicht am Schnittmuster — Nahtzugaben und Saum verändern die gebrauchte Länge.
- Reißverschlussfuß verwenden. Mit ihm kommt die Naht dicht an die Zähne, ohne dass der Fuß aufläuft.
- Vor dem Annähen beide Seiten gleich hoch ausrichten und heften. Verschiebt sich eine Hälfte, steht die Jacke am Saum auseinander.
- Bei dehnbaren Stoffen den Beleg mit Vlieseline verstärken, sonst wellt sich die Kante entlang des Bandes.
- Den Schieber vor der Quernaht öffnen und beiseiteschieben, damit die Nadel nicht auf Metall trifft.
- Metall- und Krampenverschlüsse nicht bügeln. Bei Spiralverschlüssen nur mit Tuch und niedriger Stufe.
- Beim Waschen den Verschluss schließen, dann verzieht sich das Band nicht und die Zähne haken sich nicht in anderer Wäsche fest.
Matching colour code 183
- Reißverschluss Nahtverdeckt 20 cm, Eisblau
- Reißverschluss Nahtverdeckt Länge 18 cm Eisblau
- Reißverschluss Nahtverdeckt Länge 18 cm Eisblau
- Reißverschluss Spirale 3 mm Länge 12 cm pinlock Eisblau
- Reißverschluss Spirale Breite 3 mm Länge 20 cm pinlock Eisblau
- Reißverschluss spiralförmig 3 mm, 35 cm, nicht teilbar, Eisblau
- Reißverschluss spiralförmig 3 mm, 40 cm, nicht teilbar, Eisblau
- Reißverschluss spiralförmig 3 mm, 50 cm, nicht teilbar, Eisblau
Available in more colours in the Teilbare Reißverschlüsse series.
Frequently asked questions
How do I thread it back together?
Slider all the way down, guide the pin straight into the box and push it in to the stop. Only then pull up. Entered at an angle, the pin jams and the slider jumps off again.
Which length does a jacket need?
Measure the front edge on your finished pattern piece, hem to neckline, and deduct seam allowances. Err short: too long and it stands proud at the top, too short and your hem gapes.
How do I stop the slider scratching a chin?
A small fabric tab over the upper end, or a piece of facing reaching past the slider. Either costs little effort and makes a jacket far more comfortable.
Can I run it into a hood?
Yes, then the fastener runs up into the collar. Measure to the hood's edge in that case, not only to the neckline, or it comes out too short.
Care instructions:

