Mint is a pale, cool green, almost pastel. Beside natural white and light grey it makes a very calm arrangement. At 50 cm of tooth length it fits wherever you need exactly that opening — measured on your finished pattern piece, not on paper.
A 5 mm plastic coil — the version fitted to most jackets. If the fastener should run into a hood, measure to the hood's edge rather than only to the neckline. Otherwise you end up short by exactly the centimetres you need most.
What Teilbare Reißverschlüsse Mint is suitable for
- Softshell jackets, because the fastener carries real function there.
- Cardigans, because a fastener replaces a button placket.
- Rain jackets, because a separating fastener frees the whole front.
Sewing tips
- Länge am fertigen Schnittteil messen, nicht am Schnittmuster — Nahtzugaben und Saum verändern die gebrauchte Länge.
- Reißverschlussfuß verwenden. Mit ihm kommt die Naht dicht an die Zähne, ohne dass der Fuß aufläuft.
- Vor dem Annähen beide Seiten gleich hoch ausrichten und heften. Verschiebt sich eine Hälfte, steht die Jacke am Saum auseinander.
- Bei dehnbaren Stoffen den Beleg mit Vlieseline verstärken, sonst wellt sich die Kante entlang des Bandes.
- Den Schieber vor der Quernaht öffnen und beiseiteschieben, damit die Nadel nicht auf Metall trifft.
- Metall- und Krampenverschlüsse nicht bügeln. Bei Spiralverschlüssen nur mit Tuch und niedriger Stufe.
- Beim Waschen den Verschluss schließen, dann verzieht sich das Band nicht und die Zähne haken sich nicht in anderer Wäsche fest.
Available in more colours in the Teilbare Reißverschlüsse series.
Frequently asked questions
Which length does a jacket need?
Measure the front edge on your finished pattern piece, hem to neckline, and deduct seam allowances. Err short: too long and it stands proud at the top, too short and your hem gapes.
Does it work on sweat and jersey?
Yes, with strips of interfacing in the edge. Without reinforcement, knitted cloth stretches as you sew and the fastener pulls your finished jacket crooked.
Metal or plastic — which is better?
Plastic is lighter, more flexible and quieter; metal reads stronger and takes more strain. Sweat jackets do fine with plastic; for coats and workwear, metal serves better.
How far should the topstitching sit?
About three to five millimetres beside the teeth. Too close and the slider brushes your seam; too far and the fabric throws a ripple over the tape.
Care instructions:


