Khaki is a muted green carrying brown, reading quietly military. On outdoor and utility pieces the shade belongs. At 75 cm of tooth length it fits wherever you need exactly that opening — measured on your finished pattern piece, not on paper.
This version carries 5 mm metal teeth. They take more strain than plastic but need more clearance from your needle while sewing. If the slider sticks later, fabric is usually caught between the teeth — ease it out rather than forcing it. A little candle wax on the teeth gets it running smoothly again.
What Teilbare Reißverschlüsse Khaki is suitable for
- Coats, because this length reaches the hem.
- Children's jackets, because the piece goes on and off easily.
- Covers meant to come off entirely, because both halves separate.
Sewing tips
- Länge am fertigen Schnittteil messen, nicht am Schnittmuster — Nahtzugaben und Saum verändern die gebrauchte Länge.
- Reißverschlussfuß verwenden. Mit ihm kommt die Naht dicht an die Zähne, ohne dass der Fuß aufläuft.
- Vor dem Annähen beide Seiten gleich hoch ausrichten und heften. Verschiebt sich eine Hälfte, steht die Jacke am Saum auseinander.
- Bei dehnbaren Stoffen den Beleg mit Vlieseline verstärken, sonst wellt sich die Kante entlang des Bandes.
- Den Schieber vor der Quernaht öffnen und beiseiteschieben, damit die Nadel nicht auf Metall trifft.
- Metall- und Krampenverschlüsse nicht bügeln. Bei Spiralverschlüssen nur mit Tuch und niedriger Stufe.
- Beim Waschen den Verschluss schließen, dann verzieht sich das Band nicht und die Zähne haken sich nicht in anderer Wäsche fest.
Available in more colours in the Teilbare Reißverschlüsse series.
Frequently asked questions
How do I thread it back together?
Slider all the way down, guide the pin straight into the box and push it in to the stop. Only then pull up. Entered at an angle, the pin jams and the slider jumps off again.
Can I shorten it?
From the top yes: cut it, fold the tape into your seam allowance and set a new stop with a few hand stitches. From the bottom you cannot — that is where the box and pin sit.
Metal or plastic — which is better?
Plastic is lighter, more flexible and quieter; metal reads stronger and takes more strain. Sweat jackets do fine with plastic; for coats and workwear, metal serves better.
How far should the topstitching sit?
About three to five millimetres beside the teeth. Too close and the slider brushes your seam; too far and the fabric throws a ripple over the tape.