Khaki is a muted green carrying brown, reading quietly military. On outdoor and utility pieces the shade belongs. Tooth length comes to 65 cm. Lay it against your piece before cutting and you will see at once whether the opening sits right.
5 mm metal teeth. They turn the fastener into a visible design element rather than a purely functional part. A facing tidies the front edge and covers the tape. Without one, finish your seam allowances beforehand — beside the tape, raw edges fray otherwise.
What Teilbare Reißverschlüsse Khaki is suitable for
- Coats, because this length reaches the hem.
- Children's jackets, because the piece goes on and off easily.
- Softshell jackets, because the fastener carries real function there.
Sewing tips
- Länge am fertigen Schnittteil messen, nicht am Schnittmuster — Nahtzugaben und Saum verändern die gebrauchte Länge.
- Reißverschlussfuß verwenden. Mit ihm kommt die Naht dicht an die Zähne, ohne dass der Fuß aufläuft.
- Vor dem Annähen beide Seiten gleich hoch ausrichten und heften. Verschiebt sich eine Hälfte, steht die Jacke am Saum auseinander.
- Bei dehnbaren Stoffen den Beleg mit Vlieseline verstärken, sonst wellt sich die Kante entlang des Bandes.
- Den Schieber vor der Quernaht öffnen und beiseiteschieben, damit die Nadel nicht auf Metall trifft.
- Metall- und Krampenverschlüsse nicht bügeln. Bei Spiralverschlüssen nur mit Tuch und niedriger Stufe.
- Beim Waschen den Verschluss schließen, dann verzieht sich das Band nicht und die Zähne haken sich nicht in anderer Wäsche fest.
Available in more colours in the Teilbare Reißverschlüsse series.
Frequently asked questions
What about crossing seams?
Open the fastener and push the slider out of the way before your needle arrives. Hit the slider or metal teeth and it breaks.
How do I stop the slider scratching a chin?
A small fabric tab over the upper end, or a piece of facing reaching past the slider. Either costs little effort and makes a jacket far more comfortable.
Metal or plastic — which is better?
Plastic is lighter, more flexible and quieter; metal reads stronger and takes more strain. Sweat jackets do fine with plastic; for coats and workwear, metal serves better.
How far should the topstitching sit?
About three to five millimetres beside the teeth. Too close and the slider brushes your seam; too far and the fabric throws a ripple over the tape.
Care instructions:

