A clear red with neither blue nor orange cast. On dark fabrics this fastener becomes a deliberate accent. Tooth length comes to 40 cm. Lay it against your piece before cutting and you will see at once whether the opening sits right.
That continuous coil runs 5 mm. Against metal teeth it reads less conspicuous and follows curves more softly. If the fastener should run into a hood, measure to the hood's edge rather than only to the neckline. Otherwise you end up short by exactly the centimetres you need most.
What Teilbare Reißverschlüsse Rot is suitable for
- Coats, because this length reaches the hem.
- Children's jackets, because the piece goes on and off easily.
- Rain jackets, because a separating fastener frees the whole front.
Sewing tips
- Länge am fertigen Schnittteil messen, nicht am Schnittmuster — Nahtzugaben und Saum verändern die gebrauchte Länge.
- Reißverschlussfuß verwenden. Mit ihm kommt die Naht dicht an die Zähne, ohne dass der Fuß aufläuft.
- Vor dem Annähen beide Seiten gleich hoch ausrichten und heften. Verschiebt sich eine Hälfte, steht die Jacke am Saum auseinander.
- Bei dehnbaren Stoffen den Beleg mit Vlieseline verstärken, sonst wellt sich die Kante entlang des Bandes.
- Den Schieber vor der Quernaht öffnen und beiseiteschieben, damit die Nadel nicht auf Metall trifft.
- Metall- und Krampenverschlüsse nicht bügeln. Bei Spiralverschlüssen nur mit Tuch und niedriger Stufe.
- Beim Waschen den Verschluss schließen, dann verzieht sich das Band nicht und die Zähne haken sich nicht in anderer Wäsche fest.
Matching colour code 148
Available in more colours in the Teilbare Reißverschlüsse series.
Frequently asked questions
Which length does a jacket need?
Measure the front edge on your finished pattern piece, hem to neckline, and deduct seam allowances. Err short: too long and it stands proud at the top, too short and your hem gapes.
Can I shorten it?
From the top yes: cut it, fold the tape into your seam allowance and set a new stop with a few hand stitches. From the bottom you cannot — that is where the box and pin sit.
What about crossing seams?
Open the fastener and push the slider out of the way before your needle arrives. Hit the slider or metal teeth and it breaks.
How do I care for the finished jacket?
Close the fastener before every wash. The tape then will not distort and the teeth cannot catch in other laundry. Never press directly over the slider.
Care instructions:


