Sand is a pale, warm beige — the tone unbleached cotton and linen carry. On natural fabrics you barely see this fastener. Its length is 85 cm. That is tooth length; the tape above it disappears into your seam allowance.
5 mm of coil width — the standard size for outerwear. It takes strain without reading as heavy as a metal fastener. If the slider sticks later, fabric is usually caught between the teeth — ease it out rather than forcing it. A little candle wax on the teeth gets it running smoothly again.
What Teilbare Reißverschlüsse Sand is suitable for
- Sweat jackets, because the piece opens completely.
- Zipped hoodies, because the fastener can run up into the hood.
- Children's jackets, because the piece goes on and off easily.
Sewing tips
- Länge am fertigen Schnittteil messen, nicht am Schnittmuster — Nahtzugaben und Saum verändern die gebrauchte Länge.
- Reißverschlussfuß verwenden. Mit ihm kommt die Naht dicht an die Zähne, ohne dass der Fuß aufläuft.
- Vor dem Annähen beide Seiten gleich hoch ausrichten und heften. Verschiebt sich eine Hälfte, steht die Jacke am Saum auseinander.
- Bei dehnbaren Stoffen den Beleg mit Vlieseline verstärken, sonst wellt sich die Kante entlang des Bandes.
- Den Schieber vor der Quernaht öffnen und beiseiteschieben, damit die Nadel nicht auf Metall trifft.
- Metall- und Krampenverschlüsse nicht bügeln. Bei Spiralverschlüssen nur mit Tuch und niedriger Stufe.
- Beim Waschen den Verschluss schließen, dann verzieht sich das Band nicht und die Zähne haken sich nicht in anderer Wäsche fest.
Matching colour code 307
Available in more colours in the Teilbare Reißverschlüsse series.
Frequently asked questions
Which length does a jacket need?
Measure the front edge on your finished pattern piece, hem to neckline, and deduct seam allowances. Err short: too long and it stands proud at the top, too short and your hem gapes.
Can I shorten it?
From the top yes: cut it, fold the tape into your seam allowance and set a new stop with a few hand stitches. From the bottom you cannot — that is where the box and pin sit.
Which needle do I need?
A universal needle in a suitable size; across several layers a denim needle. Never sew over the teeth themselves — a needle breaks or bends there.
How far should the topstitching sit?
About three to five millimetres beside the teeth. Too close and the slider brushes your seam; too far and the fabric throws a ripple over the tape.
Care instructions:


