Black works on nearly any fabric without long comparison. This fastener disappears on dark cloth and draws a deliberate line on pale cloth. 75 cm — that length is measured without the tape running into the seam above and below.
These metal teeth carry a rainbow coating and shift tone with the light. Here the fastener is deliberately the focal point. If the fastener should run into a hood, measure to the hood's edge rather than only to the neckline. Otherwise you end up short by exactly the centimetres you need most.
What Teilbare Reißverschlüsse Schwarz is suitable for
- Sweat jackets, because the piece opens completely.
- Zipped hoodies, because the fastener can run up into the hood.
- Softshell jackets, because the fastener carries real function there.
Sewing tips
- Länge am fertigen Schnittteil messen, nicht am Schnittmuster — Nahtzugaben und Saum verändern die gebrauchte Länge.
- Reißverschlussfuß verwenden. Mit ihm kommt die Naht dicht an die Zähne, ohne dass der Fuß aufläuft.
- Vor dem Annähen beide Seiten gleich hoch ausrichten und heften. Verschiebt sich eine Hälfte, steht die Jacke am Saum auseinander.
- Bei dehnbaren Stoffen den Beleg mit Vlieseline verstärken, sonst wellt sich die Kante entlang des Bandes.
- Den Schieber vor der Quernaht öffnen und beiseiteschieben, damit die Nadel nicht auf Metall trifft.
- Metall- und Krampenverschlüsse nicht bügeln. Bei Spiralverschlüssen nur mit Tuch und niedriger Stufe.
- Beim Waschen den Verschluss schließen, dann verzieht sich das Band nicht und die Zähne haken sich nicht in anderer Wäsche fest.
Available in more colours in the Teilbare Reißverschlüsse series.
Frequently asked questions
What about crossing seams?
Open the fastener and push the slider out of the way before your needle arrives. Hit the slider or metal teeth and it breaks.
The slider sticks — what helps?
Usually fabric is caught between the teeth; ease it out rather than forcing it. If it still runs stiff, a little candle wax on the teeth helps.
How should I store fasteners?
Flat and closed, ideally sorted by length. Stored folded, the tape keeps that crease, and you see it later along the sewn-in edge.
How far should the topstitching sit?
About three to five millimetres beside the teeth. Too close and the slider brushes your seam; too far and the fabric throws a ripple over the tape.
Care instructions:


