Steel grey is a mid grey with a slight blue cast. It reads cooler and more technical than a neutral grey. Its length is 75 cm. That is tooth length; the tape above it disappears into your seam allowance.
This version carries 5 mm metal teeth. They take more strain than plastic but need more clearance from your needle while sewing. A facing tidies the front edge and covers the tape. Without one, finish your seam allowances beforehand — beside the tape, raw edges fray otherwise.
What Teilbare Reißverschlüsse Stahlgrau is suitable for
- Zipped hoodies, because the fastener can run up into the hood.
- Between-season jackets, because they open quickly.
- Rain jackets, because a separating fastener frees the whole front.
Sewing tips
- Länge am fertigen Schnittteil messen, nicht am Schnittmuster — Nahtzugaben und Saum verändern die gebrauchte Länge.
- Reißverschlussfuß verwenden. Mit ihm kommt die Naht dicht an die Zähne, ohne dass der Fuß aufläuft.
- Vor dem Annähen beide Seiten gleich hoch ausrichten und heften. Verschiebt sich eine Hälfte, steht die Jacke am Saum auseinander.
- Bei dehnbaren Stoffen den Beleg mit Vlieseline verstärken, sonst wellt sich die Kante entlang des Bandes.
- Den Schieber vor der Quernaht öffnen und beiseiteschieben, damit die Nadel nicht auf Metall trifft.
- Metall- und Krampenverschlüsse nicht bügeln. Bei Spiralverschlüssen nur mit Tuch und niedriger Stufe.
- Beim Waschen den Verschluss schließen, dann verzieht sich das Band nicht und die Zähne haken sich nicht in anderer Wäsche fest.
Available in more colours in the Teilbare Reißverschlüsse series.
Frequently asked questions
Can I shorten it?
From the top yes: cut it, fold the tape into your seam allowance and set a new stop with a few hand stitches. From the bottom you cannot — that is where the box and pin sit.
The slider sticks — what helps?
Usually fabric is caught between the teeth; ease it out rather than forcing it. If it still runs stiff, a little candle wax on the teeth helps.
Which needle do I need?
A universal needle in a suitable size; across several layers a denim needle. Never sew over the teeth themselves — a needle breaks or bends there.
Can I run it into a hood?
Yes, then the fastener runs up into the collar. Measure to the hood's edge in that case, not only to the neckline, or it comes out too short.