A clear red with neither blue nor orange cast. On dark fabrics this fastener becomes a deliberate accent. At 50 cm of tooth length it fits wherever you need exactly that opening — measured on your finished pattern piece, not on paper.
5 mm metal teeth. They turn the fastener into a visible design element rather than a purely functional part. A small fabric tab over the upper end stops the slider scratching a chin. That costs two minutes and makes the finished jacket noticeably more comfortable.
What Teilbare Reißverschlüsse Rot is suitable for
- Zipped hoodies, because the fastener can run up into the hood.
- Children's jackets, because the piece goes on and off easily.
- Between-season jackets, because they open quickly.
Sewing tips
- Länge am fertigen Schnittteil messen, nicht am Schnittmuster — Nahtzugaben und Saum verändern die gebrauchte Länge.
- Reißverschlussfuß verwenden. Mit ihm kommt die Naht dicht an die Zähne, ohne dass der Fuß aufläuft.
- Vor dem Annähen beide Seiten gleich hoch ausrichten und heften. Verschiebt sich eine Hälfte, steht die Jacke am Saum auseinander.
- Bei dehnbaren Stoffen den Beleg mit Vlieseline verstärken, sonst wellt sich die Kante entlang des Bandes.
- Den Schieber vor der Quernaht öffnen und beiseiteschieben, damit die Nadel nicht auf Metall trifft.
- Metall- und Krampenverschlüsse nicht bügeln. Bei Spiralverschlüssen nur mit Tuch und niedriger Stufe.
- Beim Waschen den Verschluss schließen, dann verzieht sich das Band nicht und die Zähne haken sich nicht in anderer Wäsche fest.
Matching colour code 148
Available in more colours in the Teilbare Reißverschlüsse series.
Frequently asked questions
How do I stop the slider scratching a chin?
A small fabric tab over the upper end, or a piece of facing reaching past the slider. Either costs little effort and makes a jacket far more comfortable.
Metal or plastic — which is better?
Plastic is lighter, more flexible and quieter; metal reads stronger and takes more strain. Sweat jackets do fine with plastic; for coats and workwear, metal serves better.
How should I store fasteners?
Flat and closed, ideally sorted by length. Stored folded, the tape keeps that crease, and you see it later along the sewn-in edge.
Can I run it into a hood?
Yes, then the fastener runs up into the collar. Measure to the hood's edge in that case, not only to the neckline, or it comes out too short.
Care instructions:


